NCCER MILLWRIGHT PRACTICE EXAM 2 GUIDE 2025 PREP
1 /
13
1. unusual: If the seal was not properly aligned or there is excessive wear in some
bearing or shaft, wear tracks will be the indicator
2. sharpened brass putty knife: For removing hard to remove gasket materials
found on sealing surfaces, is recommended
3. Conducted on the job: Apprenticeship training is
4. distance: Charting alignment on a graph requires a chart that is divided into
thousandths of an inch vertically for the indicator readings and into whole inches
horizontally for the
5. hidden: The orthographic drawing may contain a dashed or line
6. Radiation: In order to shoot through a test object and project an image onto a
detector or a sheet of film, radiography uses a source of penetrating called
7. *scribe circles
*transfer measurements
*compare distances
<measure angles: Which of the following task would you not perform with dividers?
8. 10%: The over speed trip device is actuated when the turbine reaches a prede-
termined limit usually % above normal full-load speed
9. high: Positive results in an offset measurement mean that the MTBM is or
on the 3-o'clock side.
10. offset misalignment: The coupling gap is set, and then the is measured
11. pressure: In a hydraulic system, movement depends on
12. furniture or utility items: Fractional dimensions are used on objects such as
or
13. elimination: If the cause of the problem is not immediately understood, the
process of is often the procedure of choice
