Docsity
Docsity

Prepare for your exams
Prepare for your exams

Study with the several resources on Docsity


Earn points to download
Earn points to download

Earn points by helping other students or get them with a premium plan


Guidelines and tips
Guidelines and tips

D-NWG-FN-23 Dell Networking Foundations 2023 Dumps, Slides of Advanced Education

Passcert provides the latest D-NWG-FN-23 Dell Networking Foundations 2023 Dumps which cover all the exam content, providing you with the necessary resources to successfully pass your exam and achieve your certification goals.

Typology: Slides

2023/2024

Uploaded on 10/23/2023

victoria-meisel
victoria-meisel 🇺🇸

4

(5)

46 documents

1 / 5

Toggle sidebar

This page cannot be seen from the preview

Don't miss anything!

bg1
Download the latest DELL D-NWG-FN-23 Exam Dumps for Best Preparation
1/5
Exam :D-NWG-FN-23
Title :
https://www.passcert.com/D-NWG-FN-23.html
Dell Networking
Foundations 2023
pf3
pf4
pf5

Partial preview of the text

Download D-NWG-FN-23 Dell Networking Foundations 2023 Dumps and more Slides Advanced Education in PDF only on Docsity!

Exam : D-NWG-FN-

Title :

https://www.passcert.com/D-NWG-FN-23.html

Dell Networking

Foundations 2023

1.At which layer of the OSI model is the Rapid Spanning Tree protocol used to prevent switching loops? A. Physical B. Network C. Data Link D. Transport Answer: C 2.Which parameter is required to match an OSPF Adjacency to form? A. IP addresses B. Area ID C. Switch models D. Switch firmware version Answer: B 3.A Dell Networking N3024 has a link aggregation configured as shown: interface Gi1/0/ channel-group 1 mode active exit ! interface Gi1/0/ channel-group 1 mode active exit ! interface port-channel 1 switchport access vlan 10 exit After connecting all cables, the port-channel does NOT work as expected. As part of the troubleshooting process, the technician examines the “show lldp” displayed: What is the most likely cause for the issue on the port-channel? A. The interface port-channel is not using 10Gbps interfaces. B. The interfaces on the N2024 switches are running LACP. C. The interface port-channel is not configured in trunk mode. D. The interfaces are connected to different switches. Answer: D 4.A technician configures RIP on a new N-Series switch to connect to an existing switch that runs RIP. The routing table is not populating even after the network statements are added. What is a possible cause of this issue? A. The existing switch has not been configured with the command “hostroutesaccept”.

B. 255.255.255.

C. 255.255.255.

D. 255.255.255.

Answer: D 11.What is the maximum frequency of a CAT6 UTP cable? A. 100 MHz B. 250 MHz C. 500 MHz D. 600 MHz Answer: B 12.When configuring a switch, which CLI mode only supports limited show commands? A. EXEC B. Maintenance C. Configuration D. EXEC Privilege Answer: A 13.Which command sequence leads to the successful creation of a Layer 3 port channel on an OS switch? A. 1(config-if-po-2)# ip address 192.168.0.0/ S1(config-if-po-2)# no switchport B. S1(config-if-po-2)# ip address 192.168.0.0/ S1(config-if-po-2)# no switchport C. S1(config-if-po-2)# ip address 192.168.0.0/ S1(config-if-po-2)# switchport mode IPv D. S1(config-if-po-2)# no switchport S1(config-if-po-2)# ip address 192.168.0.0/ Answer: D 14.Which type of route is often used to direct traffic bound for the Internet? A. Redistributed B. Directly connected C. Dynamic D. Default Answer: D 15.How is a switch different from a hub? A. A switch operates at a lower, more efficient layer of the OSI model. B. A switch decreases the number of broadcast storms. C. A switch tracks MAC addresses of all connected devices. D. A switch does not include any latency into the frame transfer time. Answer: C

16.Which IEEE standard defines the Data Link Layer, Discovery protocol? A. 802.1AB B. 802.1AX C. 802.1D D. 802.1W Answer: A 17.What does the blinking yellow Activity/PoE LED indicate on an N-Series switch? A. There is no current transmit/receive activity and PoE power is off. B. There is no current transmit/receive activity and PoE power is on. C. There is current transmitting/receiving and PoE power is on. D. There is current transmitting/receiving and PoE power is off. Answer: C 18.On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured? A. C9000 Series B. N-Series C. S-Series D. Z-Series Answer: B 19.A Dell EMC Networking N-Series switch is configured on a port channel with LACP using the interfaces Te1/0/1 and Te1/0/2. How is the egress traffic distributed among the interfaces? A. Traffic overflow will be sent to the second interface B. Interfaces will be used in active/passive C. Load balanced per packet using round robin D. Load balanced using a hash function Answer: D 20.Which IPv6 scope is used for private addressing within an organization? A. APIPA B. Area wide C. Global D. Unique local Answer: D 21.Which Border Gateway Protocol (BGP) version supports IPv6? A. BGPng B. BGPv C. BGPv D. BGPv Answer: D