AutoCad Chapter 11 Exam Graded A+
Define the term displacement as it relates to the STRETCH command. - ANS-The
movement from the original position to the new position.
Describe the difference between the Trim and No trim options of the CHAMFER and
FILLET commands. - ANS-With the Trim mode active, the selected lines are trimmed
away from the chamfered or filleted corner. With the No trim option active, the selected
lines are not trimmed, and the chamfer or fillet line is only added.
Explain how to set the radius of a fillet to .50. - ANS-Enter the FILLET tool, enter the
Radius option, and enter .50
How can you split an object in two without removing a portion? - ANS-Use the BREAK
tool and specify the same point for both the first and second break points. This can be
accomplished by entering @ when prompted for the second break point.
How do you specify the size of a fillet? - ANS-With a radius dimension
Identify the LENGTHEN command option that corresponds to each of the following
descriptions: - ANS-A. Allows a positive or negative change in length from the endpoint:
DElta
B. Changes a length or an arc angle by a percentage of the total: Percent
C. Sets the total length or angle to the value specified: Total
D. Drags the endpoint of the object to the desired length or angle: Dynamic
In what direction should you pick points to break a portion out of a circle or arc? - ANS-
Counterclockwise
List locations drafters normally choose as the base point when using the STRETCH
command. - ANS-A point on an object, the corner of a view, or the center of a circle.
Name the command associated with boundary edges. - ANS-EXTEND
Name the command that trims an object to a cutting edge. - ANS-TRIM
Name the TRIM and EXTEND command option that allows you to trim or extend to an
implied intersection. - ANS-The Extend function of the Edge option.
What command can you use to combine two collinear lines into a single line object? -
ANS-JOIN
What command would you use to reduce the size of an entire drawing by one-half? -
ANS-SCALE
